How to replace the Mitsubishi Pajero’s Radiator Support both Upper and Lower Insulators The radiator support insulators supports the Pajero’s radiator while insulating the radiator from road vibrations. The rubber support insulators can also help to protect the radiator from Radiator Electrolysis. Radiator Electrolysis is a condition caused by electrical current running through the coolant. […]
Read moreTag Archives: Pajero
How to replace the Pajero Engine Coolant Temperature Sensor
I decided to replace the Pajero NW engine coolant temperature sensor to eliminate the possibility that the engine temperature coolant sensor was the cause of a coolant temperature fluctuation. The issued had started to occur in the Pajero after the Water Pump and Radiator had been replaced by NatRad. The coolant sensor I suspect would […]
Read moreFitting the HPD Catch Can to the Mitsubishi Pajero
This is a guide for installing the HPD catch can into the engine bay of a NW Pajero. It should the same for most of the Pajero models. Its broken into three parts the first is just a quick run down on the HPD catch can, then the next two are the actual fitting guide. […]
Read moreInstalling the Asfir MTM48 Rear Air Conditioner Skid Plate on the Pajero NW
The Pajero Rear Air Conditioner is positioned at the rear on the right hand side of the vehicle . It has a plastic cover to provide some protection to the air con unit which is okay for small stones being flicked up when driving on gravel roads but more substantial protection would be better if […]
Read more4WD Adventure Training Bush Course
We have owned our Mitsubishi Pajero NW for a little over a month now and decided to get a bit of training on using the Pajero offroad. We have owned and used Subarus offroad and touring for over 20 years and consider ourselves to be quite competent offroad (to the Subaru’s limits) and travel wise. […]
Read more