How to replace the Mitsubishi Pajero’s Radiator Support both Upper and Lower Insulators The radiator support insulators supports the Pajero’s radiator while insulating the radiator from road vibrations. The rubber support insulators can also help to protect the radiator from Radiator Electrolysis. Radiator Electrolysis is a condition caused by electrical current running through the coolant. […]
Read moreCategory Archives: The Pajero
How to replace the Pajero Engine Coolant Temperature Sensor
I decided to replace the Pajero NW engine coolant temperature sensor to eliminate the possibility that the engine temperature coolant sensor was the cause of a coolant temperature fluctuation. The issued had started to occur in the Pajero after the Water Pump and Radiator had been replaced by NatRad. The coolant sensor I suspect would […]
Read moreFitting the HPD Catch Can to the Mitsubishi Pajero
This is a guide for installing the HPD catch can into the engine bay of a NW Pajero. It should the same for most of the Pajero models. Its broken into three parts the first is just a quick run down on the HPD catch can, then the next two are the actual fitting guide. […]
Read moreInstalling the Asfir MTM48 Rear Air Conditioner Skid Plate on the Pajero NW
The Pajero Rear Air Conditioner is positioned at the rear on the right hand side of the vehicle . It has a plastic cover to provide some protection to the air con unit which is okay for small stones being flicked up when driving on gravel roads but more substantial protection would be better if […]
Read moreHow to remodel the Mitsubishi Pajero Battery tray
Thursday, 27th March 2016 On the way back from our last trip doing Googs Track / Gawler Ranges in South Australia we did our normal thing and went down the Old Hyden Norseman Road and cleared another 6 trees. The Warn winch was used a fair bit and the battery was flattened once or twice. […]
Read more